How to Load Paper in the Auto Cut Sheet Feeder (MP-21CDX or optional SF-21MP users only)

1. Make sure that the Latches on both sides of the Auto Cut Sheet Feeder are closed.

2. Fit the Auto Cut Sheet Feeder onto the printer. Push the latches securely until you hear them click into the lock position.

Fig. 2-9 Fit the Auto Cut Sheet Feeder onto the Printer

3. Tilt the Auto Cut Sheet Feeder fully (1). Press the center of the Feeder cover a little and open the Feeder Cover(2).

Fig. 2-10 Tilt the Feeder and Open the Cover

4. Pull the wire up.

Fig. 2-11 Pull the Wire up

5. Fan the stack of paper before loading.

6. Load the paper stack with the printing (coated) side upwards. Align the right side of the paper against the right hand side of the Auto Cut Sheet Feeder. Make sure that the paper is stacked below the mark. You can load up to approx. 30 sheets of plain paper (75g / m²).

7. Adjust the Paper Guide to the left hand side of the paper and close the Feeder Cover.

Fig. 2-12 Loading Paper

✒ Note

✒ Note